Relearn Procedure:

Note: Only If vehicles with tire pressure display function support the below auto relearn function.

1. Properly install tire pressure sensors.

2. Inflate tires to placard.

3. Park the vehicle in a safe place , using tool to activate FL, FR, RR and RL TPMS sensor one by one, and then start the engine.

4. Select the 'Setting' menu on the multi-information display using the meter control switches on the steering wheel.

5. Select 'Vehicle Settings' and then press and hold OK until enter the next interface.

6. Select 'TPWS'and then Press OK. Select 'Change Wheel' then press and hold OK until the TPMS warning light blinks 3 times. Then a message 'Setting Tire Pressure Warning System' and '- -' of each tire pressure will be displayed on the dashboard.

7. Drive vehicle at speed between 16 mph (25km/h) and 64 mph (100km/h) for about 15 minutes. Registration is complete when the TPMS light off and the inflation pressure of each tire is displayed on the dashboard. Howover , if registration does not complete after driving for 15 minutes or more, repeat from the fourth step again.

Initialize the TPMS system:

1. The TPMS system must be initialized in the following circumstances:

a. When the tire inflation pressure is changed such as when changing traveling speed , load weight or tire size.

b. When rolating the tires.

c. Vehicles with a tire inflation pressure display function: After performing the transmitter ID code Registration procedure.

2. When the tire pressure warning system is initialized, the current tire inflation pressure is set as the benchmark pressure.

3. Initialize the tire pressure warning system procedure is similar as auto relearn procedure, the only difference is to replace the select 'Change Wheel' with select 'Set Pressure' in the seventh step .