There are two minutes to match the first tire position, and five minutes overall to match all four tire positions. If it takes longer, the matching process stops and must be restarted.

Relearn Procedure:

1. Set the parking brake.

2. Turn ignition to ON position (engine off) .

3. With up level DIC: use the DIC controls on the right side of the steering wheel to scroll to the Tire Pressure screen under the DIC info page. press and hold the V (Set/Reset/SEL) button located in the center of the DIC controls.

4. With base level DIC: use the trip odometer reset stem to scroll to the Tire Pressure screen. press and hold the trip odometer reset stem for about five seconds.

5. A message asking if the process should begin should appear. Select yes and press the Reset button to confirm the selection. The horn sounds twice to signal the receiver is in relearn mode and TIRE LEARNING ACTIVE message displays on the DIC screen.

6. Begin with the front left tire. Use a relearn tool to activate the TPMS sensor near the valve stem or release the tire pressure until hearing horn chirp, that indicates the sensor identification code has been matched to this tire and wheel position.

7. Repeat step 4 for remaining tires in the following order RF RR and LR.

After completing LR tire, horn will sound twice to signal the sensor matching process has completed.

8. Turn ignition to OFF position to exit vehicle learn mode. Adjust all tires to pressure listed on tire placard.